Home › Cost Guides › Crawl Space Insulation
Cost Guide

How Much Does a Crawl Space Insulation Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$2,500 – $4,500
Most homeowners pay around $3,500 · Insulating a 1,000-square-foot crawl space — materials, fitting and air sealing together, with the floor above and the walls below both covered where the method calls for it
typical
$2,500$4,500
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Wide unfinished basement with exposed floor joists and ductwork overhead, a central staircase, water heater and painted concrete-block walls

Crawl Space Insulation cost at a glance

  • Typical range: $2,500 – $4,500
  • Most homeowners pay: around $3,500
  • Prices vary most by: Insulation material (40–60% of the budget)

Cross-checked against two published sources for this project. Sources used for this page: Angi's crawl space insulation cost guide, updated October 29, 2026 (national average $3,550 for a typical 1,000-square-foot crawl space; most $2,600–$16,900; batts $0.55–$2 per square foot installed; blown-in $1.25–$2.50; rigid foam $0.50–$2.50; spray foam $3–$8; labor $0.25–$0.50 per square foot; materials $0.30–$6.75 per square foot; most spaces 250–2,500 square feet), HomeGuide's insulation cost guide (crawl space $500–$3,700; $1.00–$4.50 per square foot installed; floor insulation for vented crawl spaces, wall and rim-joist insulation for unvented ones) and CostToRenovate's insulation types guide (crawl space walls closed-cell spray foam $1,500–$4,000; fiberglass batts $0.50–$1.50 installed; cellulose $1–$2; closed-cell $1.50–$3.50; rim joists the highest-ROI insulation job). Angi's crawl space insulation guide (April 2026) corroborates with contractor jobs at $1,500–$6,900 and DIY up to $500. Synthesized typical = the standard batt or rigid-foam job on a 1,000-square-foot crawl space at $2,500–$4,500, with $3,500 most-pay at Angi's $3,550 average rounded. Checked November 2026.. Sources last checked: October 2026 — HomeGuide, Angi. How we calculate these costs

Cost by scope

Crawl Space Insulation cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Budget — fiberglass batts between floor joists$1,500 – $2,500Angi prices a contractor job at $1,500–$6,900, and HomeGuide prices crawl space insulation at $500–$3,700; batts are the cheapest material at $0.55–$2 per square foot installed.
Standard — batt or rigid foam, 1,000 sq ft$2,500 – $4,500The typical project on this page: Angi's average for a 1,000-square-foot crawl space is $3,550, inside HomeGuide's $500–$3,700 band and CostToRenovate's $1,500–$4,000 closed-cell wall band.
Premium — closed-cell spray foam, sealed and lined$4,500 – $10,000Angi prices spray foam at $3–$8 per square foot installed, which is $3,000–$8,000 for 1,000 square feet before encapsulation, and its most-pay band runs to $16,900.

Where the money goes

Part of the jobShareNote
Insulation material40–60% of totalAngi prices materials at $0.30–$6.75 per square foot; batts $0.30–$1.50, rigid foam $0.25–$2 and spray foam $1–$4 per board foot
Installation labor25–40% of totalAngi prices labor at $0.25–$0.50 per square foot on top of materials, and a tight, low crawl space adds hours
Rim joist & air sealing5–15% of totalCostToRenovate calls the rim joist the single highest-ROI insulation job in a house; the sealing work is a small share on a batt job and is bundled into the spray-foam price
Vapor barrier, prep & access0–15% of totalZero on a clean, dry crawl space; a lined and sealed space is what pushes Angi's most-pay band toward $16,900
Insulation material · 40–60%Installation labor · 25–40%Rim joist & air sealing · 5–15%Vapor barrier, prep & access · 0–15%
Estimator’s note: on a crawl space insulation, insulation material is usually where quotes swing most (40–60% of total of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
A worker fitting an insulation membrane under roof framing: a membrane install, not batts in a crawl space — the fitting work is the same tight-space job, and Angi prices crawl space labor at $0.25–$0.50 per square foot
A worker fitting an insulation membrane under roof framing: a membrane install, not batts in a crawl space — the fitting work is the same tight-space job, and Angi prices crawl space labor at $0.25–$0.50 per square foot

What moves the price most

Material is the first lever: Angi's installed bands run $0.55–$2 per square foot for batts, $1.25–$2.50 for blown-in, $0.50–$2.50 for rigid foam board and $3–$8 for spray foam — foam is roughly four times the batt price per square foot. Size is second: Angi puts most crawl spaces at 250–2,500 square feet, so a 1,000-square-foot space is the average this page is priced on; a small crawl space can land under $1,000 in HomeGuide's band. Vented or unvented is third: HomeGuide prices floor insulation for a vented crawl space and wall plus rim-joist insulation for an unvented one — the method, not just the material, changes the bill. Access and condition are fourth: HomeGuide lists crawl spaces as a condition that raises labor, and a low, wet or debris-filled space costs more hours than a clean one. Worked example at the most-pay figure: batts $1,500 + labor $1,200 + rim joist sealing $500 + vapor barrier $300 = $3,500. For the attic above, see our attic insulation guide; for foam as the material itself, see our spray foam insulation guide, and for the sealed-space route see our crawl space encapsulation guide.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Costs in your city

Labor is the biggest variable in any remodel, and labor is local — the same bathroom can price very differently in Houston than in Boston. We are adding city editions metro by metro, each with its own labor index, permit notes and climate factors, written for that city rather than copied from this page. Wave 1: Houston, Dallas–Fort Worth, Phoenix, Atlanta, Miami–South Florida, Orlando, Tampa, Charlotte, Austin and San Antonio. Until your city's page is live, use the national range here and weight it the way contractors do: Sun Belt labor often prices near or below the national middle, while coastal California and the Northeast metros often price well above it.

How this estimate was built: the range on this page is a synthesis of at least three published industry sources (national cost guides and the Remodeling Magazine Cost vs. Value data among them), cross-checked in October 2026. We publish planning ranges, never a single pretend-precise price. Full method: How We Estimate Costs.
A tape measure across white fibrous insulation: measure the space before you buy — Angi prices crawl space materials at $0.30–$6.75 per square foot, and the wrong quantity is the easiest way to overspend
A tape measure across white fibrous insulation: measure the space before you buy — Angi prices crawl space materials at $0.30–$6.75 per square foot, and the wrong quantity is the easiest way to overspend

Frequently asked questions

How much does it cost to insulate a crawl space?

Typically $2,500–$4,500 for a 1,000-square-foot crawl space, with $3,500 the published average in Angi's guide — its average for that size is $3,550.

How much is crawl space insulation per square foot?

$1–$4.50 per square foot installed in HomeGuide's guide; Angi's installed bands run $0.55–$2 for batts and $3–$8 for spray foam.

What is the cheapest way to insulate a crawl space?

Fiberglass batts at $0.30–$1.50 per square foot for materials in Angi's data; a DIY job runs up to $500 in Angi's guide.

Is spray foam worth it in a crawl space?

Closed-cell foam is $3–$8 per square foot installed in Angi's data and seals air and moisture that batts cannot — CostToRenovate calls it the best choice for damp crawls; for dry ones batts are the value pick.

Should I insulate the floor or the crawl space walls?

HomeGuide's rule: insulate the floor above for a vented crawl space, and the walls plus rim joist for an unvented one. See our crawl space encapsulation guide for the sealed-space route.

Before you sign: get at least 3 written local quotes for the same written scope, confirm permits and who pulls them, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Crawl Space Insulation cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides