Home › Cost Guides › Concrete Steps Installation
Cost Guide

How Much Does a Concrete Steps Installation Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$1,800 – $4,500
Most homeowners pay around $3,500 · A poured-in-place set of concrete steps, 5 to 8 steps at 4 feet wide with a standard finish — old steps removed, new steps formed, poured and finished
typical
$1,800$4,500
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Broad concrete steps beside a house, with stone walls, green bushes and ivy

Concrete Steps Installation cost at a glance

  • Typical range: $1,800 – $4,500
  • Most homeowners pay: around $3,500
  • Prices vary most by: Labor (forming, pouring & finishing) (40–60% of the budget)

Cross-checked against four published sources for this project. Sources used for this page: Angi's concrete steps cost guide, updated October 9, 2026 (national average $3,500, most $600–$5,000, range $400–$6,000; 4-foot-wide step $200–$600, 3-foot $150–$450, 5-foot $250–$750, 6-foot $300–$900; solid poured steps about $600 per step, hollow precast about $200; labor $600–$1,600, about 50% of the total; poured $1,800–$6,000, precast $600–$2,000; removal $200–$400 or $2–$6 per square foot; contractors $50–$150 per hour), HomeGuide's concrete steps cost guide, updated December 29, 2025 (poured $200–$500 per step, $1,000–$5,000 for 5–10 steps; precast $100–$350 per step, $500–$3,500 total; precast labor $100–$800; permit $100–$1,000; stamped finish $8–$19 per square foot extra; railings $20–$250 per linear foot) and HomeAdvisor's June 2025 concrete steps cost data as synthesized by ThePricer in April 2026 ($400–$6,000, average $3,500; most pay $1,800–$4,500; 5-step precast about $500–$1,750, 5-step poured $1,000–$3,000+). Synthesized typical = the poured-in-place mid-range overlap at $1,800–$4,500, with $3,500 most-pay where Angi's and HomeAdvisor's national averages agree. Checked November 2026.. Sources last checked: October 2026 — HomeAdvisor, HomeGuide, Angi, ThePricer. How we calculate these costs

Cost by scope

Concrete Steps Installation cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Budget — precast drop-in steps, 3–5 steps$600 – $2,000Angi prices precast steps at $600–$2,000 installed and HomeGuide at $500–$3,000 for 5–10 steps — mass-made units dropped in, about a third of the price of poured.
Standard — poured-in-place, 5–8 steps$1,800 – $4,500The typical project on this page: the poured mid-range overlap of Angi's $1,800–$6,000 poured band and HomeGuide's $1,000–$5,000 for 5–10 poured steps.
Premium — poured, 8–10 steps with railings, stamped finish and removal$4,000 – $6,000Angi's range tops out at $6,000; HomeGuide prices a stamped finish at $8–$19 per square foot extra and railings at $20–$250 per linear foot.

Where the money goes

Part of the jobShareNote
Concrete & materials25–40% of totalAngi prices a 4-foot-wide step at $200–$600, with solid poured steps at about $600 per step and hollow precast at about $200
Labor (forming, pouring & finishing)40–60% of totalAngi prices labor at $600–$1,600 and at about 50% of the total; contractors charge $50–$150 per hour and price most jobs flat
Removal of old steps5–15% of totalAngi prices removing concrete stairs at $200–$400, or $2–$6 per square foot
Railings, finish & permits5–15% of totalHomeGuide prices railings at $20–$250 per linear foot, a stamped finish at $8–$19 per square foot extra, and a building permit at $100–$1,000
Concrete & materials · 25–40%Labor (forming, pouring & finishing) · 40–60%Removal of old steps · 5–15%Railings, finish & permits · 5–15%
Estimator’s note: on a concrete steps installation, labor (forming, pouring & finishing) is usually where quotes swing most (40–60% of total of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
A modern concrete entrance — the same poured-in-place steps at a larger scale: Angi prices a 4-foot-wide step at $200–$600, and poured steps at $1,800–$6,000
A modern concrete entrance — the same poured-in-place steps at a larger scale: Angi prices a 4-foot-wide step at $200–$600, and poured steps at $1,800–$6,000

What moves the price most

Precast or poured is the first lever: Angi prices precast steps at $600–$2,000 installed against $1,800–$6,000 poured — precast is about a third of the price because the units are mass-made off-site, but only in standard sizes. Step count and width are second: Angi prices a 3-foot-wide step at $150–$450, a 4-foot step at $200–$600 and a 6-foot step at $300–$900 — width is the single biggest per-step driver. Removal is third: Angi prices removing old concrete stairs at $200–$400, and a cracked or heaved set that has to come out first adds that line before the new steps start. Finish and railings are fourth: HomeGuide prices a stamped finish at $8–$19 per square foot extra and railings at $20–$250 per linear foot, and a permit at $100–$1,000 where the job needs one. Worked example at the most-pay figure: concrete & materials $1,200 + labor $1,400 + old-step removal $300 + railings & permit $600 = $3,500. For the concrete around the steps, see our concrete driveway guide and our concrete patio guide, and for the path to the steps see our walkway installation guide.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Costs in your city

Labor is the biggest variable in any remodel, and labor is local — the same bathroom can price very differently in Houston than in Boston. We are adding city editions metro by metro, each with its own labor index, permit notes and climate factors, written for that city rather than copied from this page. Wave 1: Houston, Dallas–Fort Worth, Phoenix, Atlanta, Miami–South Florida, Orlando, Tampa, Charlotte, Austin and San Antonio. Until your city's page is live, use the national range here and weight it the way contractors do: Sun Belt labor often prices near or below the national middle, while coastal California and the Northeast metros often price well above it.

How this estimate was built: the range on this page is a synthesis of at least three published industry sources (national cost guides and the Remodeling Magazine Cost vs. Value data among them), cross-checked in October 2026. We publish planning ranges, never a single pretend-precise price. Full method: How We Estimate Costs.
Weathered concrete treads with a handrail above: HomeGuide prices railings at $20–$250 per linear foot, and a stamped finish at $8–$19 per square foot extra
Weathered concrete treads with a handrail above: HomeGuide prices railings at $20–$250 per linear foot, and a stamped finish at $8–$19 per square foot extra

Frequently asked questions

How much does it cost to install concrete steps?

Typically $1,800–$4,500 for a poured-in-place set, averaging $3,500 — Angi's national average is $3,500 and HomeAdvisor reports the same average.

How much is one concrete step?

About $200–$600 for a 4-foot-wide step in Angi's data; a 3-foot step is $150–$450 and a 6-foot step $300–$900 — width is the single biggest per-step driver.

Are precast concrete steps cheaper?

Yes — Angi prices precast steps at $600–$2,000 installed against $1,800–$6,000 poured, because precast units are mass-made off-site; the trade-off is standard sizes only.

How much does it cost to remove old concrete steps?

$200–$400 in Angi's data, or $2–$6 per square foot — and HomeGuide prices a permit at $100–$1,000, which some jobs need.

How long do concrete steps take to install?

Angi's local guides put installation at 5–15 hours of work excluding curing for a standard set; poured steps need forming and curing time that precast drop-ins skip. See our concrete driveway guide for the same crew's other work.

Before you sign: get at least 3 written local quotes for the same written scope, confirm permits and who pulls them, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Concrete Steps Installation cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides

Worker guiding a concrete pump hose over a reinforced slab

Concrete Sidewalk Installation Cost

$1,500 – $2,800

A concrete sidewalk installation typically costs $1,500 – $2,800 for about 200 square feet of standard 4-inch concrete with a broom finish, with about $2,000 the figure most jobs land near — Angi averages $2,000 for a 200-square-foot walkway inside its $1,600–$2,400 band at about $10 per square foot, and HomeGuide averages $1,400–$3,400 at $7–$17 per square foot. The guides use walkway and sidewalk interchangeably because the materials and process are identical; the finish is what moves a job across the band, not the name.

Patio with an irregular flagstone-like pattern

Stamped Concrete Installation Cost

$3,200 – $7,600

New stamped concrete patio of about 400 sq ft, installed — about $8–$19 per sq ft for a standard pattern and color

Red-brick house with a tall chimney and white garage doors

Brick Repointing Cost

$500 – $2,500

Repointing 100 sq ft of brick wall at ground level — about $3–$20 per sq ft for walls up to 8 ft high

Stone house with a covered porch and dark double glass entry doors at dusk

Storm Door Installation Cost

$350 – $700

The typical project is one standard single storm door — full-view or self-storing, aluminum or composite — fitted to an existing, sound entry frame. Security doors, double doors and openings that need reframing are what move the job above the band.

Pool patio shaded by large white shade sails over a paved patio

Pergola Installation Cost

$2,100 – $6,400

The typical project is a standard 10-by-10-foot pergola — a kit or standard wood build — assembled and anchored on an existing patio or deck. Custom builds, large footprints and louvered roofs are what push the job above the band.

Raised round stone-clad spa beside a backyard pool on a stamped-concrete patio

Hot Tub Installation Cost

$6,000 – $11,000

The typical project is a standard above-ground hot tub fully installed — a value-priced acrylic tub delivered and placed on a new or existing base, with a new dedicated 240-volt circuit, permits and start-up included. In-ground and custom spas are priced in the top tier.