Home › Cost Guides › Driveway Replacement
Cost Guide

How Much Does a Driveway Replacement Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$3,200 – $7,200
Most homeowners pay around $6,000 · Typical 2-car driveway of about 600 sq ft, old surface torn out and replaced — about $4 – $15 per sq ft all-in, including removal
typical
$3,200$7,200
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Two-story suburban house with a spacious concrete driveway and greenery

Driveway Replacement cost at a glance

  • Typical range: $3,200 – $7,200
  • Most homeowners pay: around $6,000
  • Per square foot: $4 – $15 per sq ft
  • Prices vary most by: Labor (removal, prep, install & finishing) (40–55% of the budget)

Cross-checked against two published sources for this project. Sources used for this page: HomeGuide's driveway cost guide, updated December 19, 2025 (replacement $4–$15 per sq ft including $1–$3 per sq ft removal; 600 sq ft replacement $1,800–$7,200; concrete $6–$15, asphalt $5–$12+, pavers $10–$30 per sq ft; labor about 50% of total; permits $50–$200; concrete 30–40 yr, asphalt 15–30 yr, pavers 25–75 yr), Angi's asphalt driveway cost guide, updated October 14, 2026 (national average $5,352, most pay $3,154–$7,558; replacement $8–$15 per sq ft including $1–$2 removal; labor $5–$7 per sq ft) and Angi's concrete driveway cost guide, updated October 29, 2026 (national average $6,400; replacement $8–$20 per sq ft; labor about half, $2–$10 per sq ft; 24×24 ft $4,600–$8,600), and CostToRenovate's driveway replacement cost guide (nationally $2,500–$10,000, average $5,000, $5–$25 per sq ft, average $12; tiers $2,400 budget / $4,900 mid-range / $10,700 premium; concrete demolition $2–$5 per sq ft; base prep $500–$2,000; typical timeline 3–5 days). Synthesized typical = the $3,200–$7,200 overlap of all three sources' bands for a standard 2-car driveway of about 600 sq ft, with $6,000 most-pay inside every source's typical band. Checked November 2026.. Sources last checked: October 2026 — HomeGuide, Angi. How we calculate these costs

Cost by scope

Driveway Replacement cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Asphalt replacement (budget)$3,200 – $5,500About 600 sq ft: old asphalt torn out and hauled, base repaired and regraded, 2–3 inches of new hot-mix asphalt — the lowest-cost full replacement
Plain concrete replacement (standard)$4,800 – $8,600About 600 sq ft: old slab broken out and hauled, base regraded and compacted, a 4-inch broom-finish concrete pour with control joints — where most replacements land
Pavers or stamped concrete (premium)$9,000 – $18,000+Pavers at $10–$30 per sq ft or stamped concrete at $12–$20, a 3-car or long driveway, thicker slab, decorative borders or added drainage and apron work

Where the money goes

Part of the jobShareNote
New surface materials30–45% of totalThe material you choose sets this line — asphalt is the cheapest per square foot, plain concrete sits in the middle, pavers and stamped concrete at the top
Labor (removal, prep, install & finishing)40–55% of totalLabor is about half the job in every published guide: breaking out the old surface, setting forms, placing and finishing the new surface, and cutting control joints
Old driveway removal & disposal10–20% of totalBreaking up and hauling the old surface — asphalt removal runs $1–$3 per sq ft, concrete $2–$6, and a 600 sq ft concrete slab produces several tons of debris
Base prep, grading & drainage5–15% of totalRepairing and recompacting the gravel base and grading the slope so water drains away from the house — a failed base is what kills a new driveway early
Permits & extras1–5% of totalMost cities require a permit for a replacement at $50–$200, plus sealing on asphalt and any apron or drainage fixes the job turns up
New surface materials · 30–45%Labor (removal, prep, install & finishing) · 40–55%Old driveway removal & disposal · 10–20%Base prep, grading & drainage · 5–15%Permits & extras · 1–5%
Estimator’s note: on a driveway replacement, labor (removal, prep, install & finishing) is usually where quotes swing most (40–55% of total of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
Workers in safety gear pouring concrete from a mixer truck — the pour is the fast part of a replacement; tearing out the old driveway and rebuilding the base are the lines that push replacement above new-build pricing, with Angi putting asphalt replacement at $8–$15 per square foot against $7–$13 for a new asphalt driveway
Workers in safety gear pouring concrete from a mixer truck — the pour is the fast part of a replacement; tearing out the old driveway and rebuilding the base are the lines that push replacement above new-build pricing, with Angi putting asphalt replacement at $8–$15 per square foot against $7–$13 for a new asphalt driveway

What moves the price most

Material choice is the first cliff: asphalt replacement runs $8–$15 per sq ft (Angi) against plain concrete at $8–$20 and pavers at $10–$30 (HomeGuide), so the same 600 sq ft driveway can cost two or three times as much on surface alone — and concrete lasts 30–40 years against asphalt's 15–30, so the cheaper surface is not always the cheaper driveway. What is coming out is second: breaking out old asphalt costs $1–$3 per sq ft, while a concrete slab costs $2–$6 to break up and haul, which is why a concrete-to-asphalt swap saves less than the material prices suggest. Base condition is third: a sound base that only needs regrading keeps the job near the bottom of its band, while soft, clay-heavy or poorly drained soil needs excavation and a rebuilt 4–8 inch compacted gravel base — CostToRenovate puts that work at $500–$2,000. Size and shape come fourth — a straight rectangular 2-car pad prices at the low end per square foot, while curved, circular or long driveways add forming, cutting and material on every foot. Finally, location and permits: labor rates and permit fees vary by city, and most cities require a permit for a replacement ($50–$200) even when a repair would not need one. Worked example at the most-pay figure: old asphalt removal $900 + base repair and grading $600 + new asphalt materials $1,500 + paving labor $3,000 = $6,000. For the material guides behind these numbers, see our concrete driveway guide, our asphalt driveway guide and our paver installation guide, and for the cheaper alternative when the base is sound, see our driveway resurfacing guide.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Costs in your city

Labor is the biggest variable in any remodel, and labor is local — the same bathroom can price very differently in Houston than in Boston. We are adding city editions metro by metro, each with its own labor index, permit notes and climate factors, written for that city rather than copied from this page. Wave 1: Houston, Dallas–Fort Worth, Phoenix, Atlanta, Miami–South Florida, Orlando, Tampa, Charlotte, Austin and San Antonio. Until your city's page is live, use the national range here and weight it the way contractors do: Sun Belt labor often prices near or below the national middle, while coastal California and the Northeast metros often price well above it.

How this estimate was built: the range on this page is a synthesis of at least three published industry sources (national cost guides and the Remodeling Magazine Cost vs. Value data among them), cross-checked in October 2026. We publish planning ranges, never a single pretend-precise price. Full method: How We Estimate Costs.
A close-up of brick pavers in a herringbone pattern — pavers are the premium replacement surface at $10–$30 per square foot installed, and individual pavers can be lifted and reset if one settles or cracks, which a poured slab cannot offer
A close-up of brick pavers in a herringbone pattern — pavers are the premium replacement surface at $10–$30 per square foot installed, and individual pavers can be lifted and reset if one settles or cracks, which a poured slab cannot offer

Frequently asked questions

How much does it cost to replace a driveway per square foot?

A full replacement runs about $4–$15 per square foot all-in including removal (HomeGuide), with CostToRenovate putting the national range at $5–$25 and an average of $12. Asphalt replacement is $8–$15 per sq ft and concrete replacement $8–$20 (Angi), so a standard 2-car driveway of about 600 sq ft lands in the $3,200–$7,200 typical band on this page.

How much does it cost to tear out an old driveway?

Removal and haul-away runs $1–$3 per square foot for asphalt and $2–$6 per square foot for concrete, so tearing out a 600 sq ft driveway adds roughly $600–$1,800 for asphalt or $1,200–$3,600 for concrete before the new surface starts. Concrete costs more because it is thicker, heavier and has to be broken into pieces before loading.

How long does a driveway replacement take?

Published guidance puts a typical replacement at 3–5 days of work: a day to demolish and remove the old surface, a day for excavation and grading, a day for the base and the pour or paving. Complex jobs run 1–2 weeks. The wait after that is curing: asphalt needs 48–72 hours before driving, concrete 7–10 days.

Is it cheaper to resurface or replace a driveway?

Resurfacing is the cheaper route — HomeGuide prices it at $1–$7 per square foot against $4–$15 for replacement, and Angi puts an asphalt overlay at $3–$7 against $8–$15 for replacement. But an overlay only works when the existing surface and base are sound; resurfacing over cracked, settled or heaved slabs fails again quickly, and then you pay for both jobs.

Do I need a permit to replace a driveway?

Most cities require a permit for a driveway replacement, especially if you change the size, material or drainage pattern — a repair usually does not need one. Published guides put the fee at $50–$200 in most places, and some cities waive it where a paved apron to the street already exists.

How long will a new driveway last?

Published guidance commonly puts a well-built concrete driveway at 30–40 years, asphalt at 15–30 years with sealing every 3–5 years, and pavers at 25–75 years depending on maintenance and weather. The base is what decides it: a compacted gravel base, correct thickness and drainage away from the slab separate a 40-year driveway from a cracked 10-year one.

Before you sign: get at least 3 written local quotes for the same written scope, confirm permits and who pulls them, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Driveway Replacement cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides

Exposed wooden beams in a house under construction, showing the structural timber framing

House Leveling Cost

$3,000 – $9,500

Leveling a pier-and-beam house typically costs $3,000 – $9,500, with about $6,500 the most-pay figure — Modernize and EngineerFix agree on that band and average, and the work is hydraulic jacks, reshimming and pier, beam or joist repair under the floor, not a new foundation; a settled slab is priced by underpinning instead, and a full lift with foundation replacement runs far past this page.

An abandoned empty inground pool in an Arizona backyard, its floor covered in dirt and debris, with overgrown plants and a clear blue sky

Pool Removal Cost

$5,000 – $8,000

Removing an inground swimming pool — a partial fill-in or a full demolition and haul-away, with fill dirt, permits and regrading, at about $13.50 per square foot

Yellow excavator digging in open soil at a construction site

Septic Tank Replacement Cost

$3,000 – $7,000

Replacing just the septic tank — a new 1,000-gallon concrete tank set in the existing hole while the drain field stays in service — typically costs $3,000–$7,000, with most homeowners landing at $6,000 for the common 1,000-gallon concrete job.

Orange excavator tearing down a brick house, rooms exposed

House Demolition Cost

$6,000 – $25,000

Tearing down a whole single-family house — permits, utility cut-and-cap, excavator demolition, debris hauling and site grading — typically costs $6,000–$25,000, averaging $15,800 for a 2,000-square-foot home in Angi's 2026 data.

Wood-frame structure going up on a building site

Detached Garage Construction Cost

$25,000 – $33,600

Building a standard 2-car detached garage — about 400–480 sq ft, stick-built on a concrete slab with asphalt shingles, vinyl siding and two standard doors — typically costs $25,000–$33,600, with most homeowners paying around $26,400, about $50–$70 per sq ft. The wider published spread is $18,000–$57,600.

Three metal-clad barns with metal roofs in a green field

Pole Barn Construction Cost

$15,000 – $50,000

Building a pole barn — typically a 30×40 ft (1,200 sq ft) enclosed shell with a concrete floor, posts, trusses and a metal roof and siding — typically costs $15,000–$50,000, with most homeowners paying around $27,500, about $15–$40 per sq ft for a basic installed shell.