Home › Cost Guides › Boiler Replacement
Cost Guide

How Much Does a Boiler Replacement Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$3,200 – $9,000
Most homeowners pay around $6,100 (HomeGuide) · A residential boiler replacement (equipment + labor) averages $6,100 — HomeGuide’s national figure (updated December 2025), with typical full swaps landing at $3,200–$9,000. This Old House puts equipment + labor at $4,500–$10,000; Modernize (August 2026) averages $6,500–$11,500 — its bands skew toward full installs rather than simple swaps. Gas is the most common fuel; high-efficiency/condensing models cost a clear premium. Figures no source publishes: a distinct national ‘most-pay’ figure, per-sq-ft installed pricing, and a 50% repair-vs-replace rule.
typical
$3,200$9,000
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
White panel radiator on a brick wall

Boiler Replacement cost at a glance

  • Typical range: $3,200 – $9,000
  • Most homeowners pay: around $6,100 (HomeGuide)

Cross-checked against three published sources for this project. Sources used for this page: the HomeGuide boiler replacement cost guide (updated December 2025), This Old House’s boiler replacement cost guide (2026) and Modernize’s boiler replacement cost guide (updated August 2026). Sources last checked: October 2026 — This Old House, HomeGuide, Modernize. How we calculate these costs

Cost by scope

Boiler Replacement cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Standard-efficiency swap$2,200 – $7,000HomeGuide’s installed band for standard-efficiency replacements — 80–89% AFUE, like-for-like swap, no fuel switch
High-efficiency / condensing$4,000 – $10,000HomeGuide: 90–95%+ AFUE; This Old House notes premium models reach 95–98% AFUE; venting and a condensate drain add $200–$600
Gas boiler — most common$4,000 – $9,000HomeGuide installed band (unit $1,400–$5,600); Modernize’s gas band is $6,000–$10,500 — the honest overlap is $6,000–$9,000
Oil boiler$3,300 – $9,000HomeGuide: standard-efficiency $3,300–$7,200, high-efficiency $6,300–$9,000 (unit $1,700–$6,500); an oil-tank replacement adds $1,000–$6,200
Electric / combi / steam$6,000 – $12,500Per-source, not merged — HomeGuide electric $1,800–$8,000 vs Modernize $7,500–$12,500 (genuine disagreement); combi $6,000–$10,000; steam $7,000–$12,500 (Modernize)

Where the money goes

Part of the jobShareNote
Boiler unit$1,400 – $6,500HomeGuide’s unit band — brand moves it: Buderus/Bosch $1,700–$4,400, Burnham $1,700–$5,500, Utica up to $7,400 installed $10,600
Installation labor and fitting$1,200 – $3,200HomeGuide $1,200–$3,200; This Old House ~$2,000; Modernize $2,000–$5,000 — labor sits in the low-to-mid thousands across all three sources
Removal of the old boiler$200 – $500HomeGuide, with disposal — more for units over 200 lb or hard-to-access basements
Venting, condensate, permits$250 – $1,250Condensate drain $200–$600 on high-efficiency units, permits $50–$250 (HomeGuide); gas-line hookup $0–$2,000; chimney liner $1,500–$4,000 if needed
Add-ons$250 – $6,200Radiators $250–$500 each, HVAC zoning $1,700–$4,500, Manual J calculation $200–$500, oil-tank replacement $1,000–$6,200 (HomeGuide)
Installation labor and fitting runs $1,200–$3,200 (HomeGuide) — a same-size, same-fuel swap is the cheapest replacement.
Installation labor and fitting runs $1,200–$3,200 (HomeGuide) — a same-size, same-fuel swap is the cheapest replacement.

What moves the price most

Fuel type sets the band. Gas ($4,000–$9,000 installed) is the most common; oil ($3,300–$9,000) is most popular in the Northeast; electric ($1,800–$8,000 per HomeGuide, $7,500–$12,500 per Modernize — a genuine disagreement) and combi/steam cost more. Efficiency (AFUE) is the next lever: standard 80–89% at $2,200–$7,000 installed vs high-efficiency 90–95%+ at $4,000–$10,000 (HomeGuide), saving 10–20% on energy bills. Size (25–50 BTU/sq ft) scales with the home — This Old House’s installed bands run $4,000–$6,000 for a 1,000 sq ft home up to $6,000–$10,000 at 3,000 sq ft. Brand matters (Buderus through Utica, $1,200–$7,400 unit-only). Labor rates run $45–$150/hr. Venting/condensate, gas-line or chimney-liner work, fuel switching, radiator condition and zoning all add lines to the invoice; a same-size, same-fuel swap is the cheapest replacement. ENERGY STAR gas boilers at ≥95% AFUE qualify for a 30% federal tax credit up to $600 (This Old House).

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Costs in your city

Labor is the biggest variable in any remodel, and labor is local — the same bathroom can price very differently in Houston than in Boston. We are adding city editions metro by metro, each with its own labor index, permit notes and climate factors, written for that city rather than copied from this page. Wave 1: Houston, Dallas–Fort Worth, Phoenix, Atlanta, Miami–South Florida, Orlando, Tampa, Charlotte, Austin and San Antonio. Until your city's page is live, use the national range here and weight it the way contractors do: Sun Belt labor often prices near or below the national middle, while coastal California and the Northeast metros often price well above it.

How this estimate was built: the range on this page is a synthesis of at least three published industry sources (national cost guides and the Remodeling Magazine Cost vs. Value data among them), cross-checked in October 2026. We publish planning ranges, never a single pretend-precise price. Full method: How We Estimate Costs.
Controls and venting: a condensate drain adds $200–$600 on high-efficiency units and permits run $50–$250 (HomeGuide).
Controls and venting: a condensate drain adds $200–$600 on high-efficiency units and permits run $50–$250 (HomeGuide).

Frequently asked questions

How much does boiler replacement cost?

Equipment + labor averages $6,100 (HomeGuide, December 2025) with typical full swaps at $3,200–$9,000. This Old House puts it at $4,500–$10,000; Modernize (August 2026) averages $6,500–$11,500 — its bands skew toward full installs.

How much does a gas boiler cost?

A gas boiler replacement runs $4,000–$9,000 installed (HomeGuide; unit $1,400–$5,600). Modernize’s gas band is $6,000–$10,500 — the honest overlap is $6,000–$9,000. Gas is the most common fuel.

Standard vs high-efficiency boiler cost?

Standard-efficiency (80–89% AFUE): $2,200–$7,000 installed. High-efficiency (90–95%+ AFUE): $4,000–$10,000 installed (HomeGuide). High-efficiency saves 10–20% on energy bills; premium models reach 95–98% AFUE (This Old House).

How much is labor to replace a boiler?

Installation labor and fitting runs $1,200–$3,200 (HomeGuide), ~$2,000 (This Old House) or $2,000–$5,000 (Modernize) at $45–$150/hr for plumbers/HVAC techs.

Should I repair or replace my boiler?

Boiler repairs run $200–$600 (HomeGuide) or $200–$1,000, with major component failures $1,200–$3,000+ (Modernize). HomeGuide: replace when the unit is over 15 years old; This Old House: replace past ~15-year lifespan, on frequent costly breakdowns, or when efficiency is far below 95–98% AFUE. No source publishes a 50% repair-vs-replace rule.

How long does a boiler last?

15+ years per manufacturer guidance (This Old House, citing Viessmann); replace past 15 years when warning signs appear — energy-bill spikes, frequent repairs, loud noises, soot buildup on oil units or corrosion (HomeGuide).

Before you sign: get at least 3 written local quotes for the same written scope, confirm permits and who pulls them, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Boiler Replacement cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides

Home inspector examining a crawl space entrance

Crawl Space Encapsulation Cost

$5,000 – $15,000

Professional crawl space encapsulation averages $5,500 — Angi and This Old House (both 2026) publish the same average, with typical totals of $5,000–$15,000 (Modernize agrees, September 2026). Basic work runs $2–$4/sq ft (Angi) to $3–$7/sq ft (This Old House); extensive moisture-problem jobs reach $10/sq ft. Labor is 50–70% of the total; materials are 30–50% (Angi, This Old House).

Exposed sheet-metal air ducts and a supply register on a dark ceiling

Ductwork Replacement Cost

$1,400 – $5,600

Replacing a home’s air ducts averages $3,500 — HomeGuide’s national figure across 399 member projects (updated December 2025), with the typical range at $1,400–$5,600 by home size. This Old House (2026, Homewyse data) prices it at $16–$19 per linear foot — about $3,100–$3,700 for an average 200-foot system — and CostHelper (2026) agrees with HomeGuide’s installed band at $35–$55 per foot. No source publishes a labor-vs-materials percentage split; HomeGuide’s average is the only published national figure.

Hand adjusting a modern black smart thermostat with a Wi-Fi icon on the wall

Smart Thermostat Installation Cost

$200 – $500

A smart thermostat installed by a pro averages $300 — Fixr’s national figure (updated January 2025) for a C-wire install plus an auto-schedule smart thermostat with a two-year warranty. HomeGuide (August 2025) puts the average smart install at $225–$400; Angi (July 2026) gives the widest band, $175 to over $1,000, with the high end reserved for relocations, new wiring and multi-unit jobs. No source publishes a labor-vs-device percentage split; Fixr’s average is the only smart-only national figure.

Two workers inspecting a brick chimney with clay flue tiles and a rain cap on a rooftop

Chimney Liner Replacement Cost

$1,500 – $5,000

A standard chimney reline averages $2,500 — Angi’s national figure (updated September 2026), with typical pro jobs landing at $1,500–$5,000. HomeGuide (February 2026) averages relining at $1,200–$4,600; Flue-Pipes’ 2026 guide prices a professional stainless reline at $1,500–$3,800, with complex jobs — tall chimneys, difficult access, cast-in-place liners — reaching $7,000 or more. Angi is the only source publishing a national average; Flue-Pipes’ labor share (40–60% of the pro price) is the only published percentage.

Technician repairing electrical equipment on a workbench, motor and wiring in hand

Furnace Repair Cost

$350 – $505

A typical furnace repair lands at $350–$505 — the honest overlap of the three published typical ranges: HomeAdvisor (Angi) $133–$505, Fixr $150–$600 and Modernize $350–$900. Published averages disagree more than the ranges do: $318 (HomeAdvisor), $350–$400 (Fixr) and around $600 (Modernize, whose average pulls in major repairs). $350 is published here as the most-pay figure because it sits inside Fixr’s average band and just above HomeAdvisor’s; it is not a cross-source average. Major repairs run to $2,000+ and heat-exchanger replacement to $3,500.

HVAC technician kneeling beside a large outdoor unit with manifold gauges in hand

HVAC Maintenance Cost

$175 – $300

Annual HVAC maintenance typically costs $175 – $300 for a one-system plan with two seasonal tune-ups, with about $250 the figure most plans land near — Angi prices annual tune-ups at $175–$350 with a $250 average, and HomeGuide prices an annual service at $150–$300. This guide prices a maintenance plan for one system — inspection, cleaning and tune-ups for heating and cooling — not repairs, which are billed separately.