Home › Cost Guides › Track Lighting Installation
Cost Guide

How Much Does a Track Lighting Installation Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$200 – $500
Most homeowners pay around $350 · One track run with its spot heads, wired to an existing ceiling junction box in a single room — track, heads and the electrician's installation included; new wiring, a second run and designer heads priced separately
typical
$200$500
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Open-plan kitchen and living area lit by two black ceiling track runs

Track Lighting Installation cost at a glance

  • Typical range: $200 – $500
  • Most homeowners pay: around $350
  • Prices vary most by: Electrician labor (35–50% of the budget)

Cross-checked against three published sources for this project. Sources used for this page: Angi's light fixture installation cost guide, updated September 2, 2026 (track $100–$300 with existing wiring, plus $100–$200 for new wiring and junction boxes; fixture types fixed $80–$200, monorail $120–$300, pendant track $150–$400, cable $100–$250 per fixture; electrician labor $35–$100 per hour over about two hours), HomeGuide's light fixture installation cost guide (track lighting $100–$300 with labor, fixture alone $50–$150; replacement $100–$450) and HomeAdvisor's light fixture replacement cost data (track fixture $25–$420, average $220; swap about 1 hour at roughly $75; conversion from another fixture type 3 hours at $150–$300; total average $350 per fixture, range $75–$800). Synthesized typical = a single track run with several heads at the HomeAdvisor average, inside the Angi/HomeGuide per-system bands. Checked November 2026.. Sources last checked: October 2026 — HomeAdvisor, HomeGuide, Angi. How we calculate these costs

Cost by scope

Track Lighting Installation cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Short track swap, existing box$100 – $300Angi prices track installation at $100–$300 where overhead wiring already exists, and HomeGuide prices track installation at $100–$300 with labor — the entry job on this page.
Standard single-room track run$200 – $500The typical project on this page: one track run with four or five heads. HomeAdvisor averages $350 per track fixture installed, inside its $75–$800 range.
Multi-track, monorail or new wiring$500 – $1,200Angi adds $100–$200 for new wiring and junction boxes, and a second run, monorail bends or a dimmer system stack on top — Angi prices pendant track heads at $150–$400 each.

Where the money goes

Part of the jobShareNote
Track, heads and bulbs30–45% of totalHomeGuide prices the fixture alone at $50–$150; Angi prices fixed heads at $80–$200, monorail at $120–$300 and pendant track at $150–$400 per fixture
Electrician labor35–50% of totalAngi prices electrician labor at $35–$100 per hour over about two hours, roughly $50–$250 for the visit
New wiring, junction box or dimmer10–25% of totalAngi adds $100–$200 where new wiring and boxes are needed; a dimmer is the usual extra on a track job
Old fixture removal and patching5–10% of totalRemoving the old fixture and touching up the ceiling where a larger or differently placed fitting leaves marks
Track, heads and bulbs · 30–45%Electrician labor · 35–50%New wiring, junction box or dimmer · 10–25%Old fixture removal and patching · 5–10%
Estimator’s note: on a track lighting installation, electrician labor is usually where quotes swing most (35–50% of total of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
A long single track over a living room — Angi prices track installation at $100–$300 where the junction box already exists, with $100–$200 added for new wiring.
A long single track over a living room — Angi prices track installation at $100–$300 where the junction box already exists, with $100–$200 added for new wiring.

What moves the price most

An existing junction box is the first lever: Angi prices track installation at $100–$300 where overhead wiring can be tapped into, against $100–$200 more where new wiring and boxes are needed — a new location is a different quote from a swap. Head count is second, but not proportionally: the whole run shares one feed, so extra heads add mostly product cost rather than another visit's labor. Track type is third: Angi prices fixed track at $80–$200 per fixture, monorail at $120–$300 and pendant track at $150–$400, so the style decision moves the total before labor is even counted. Worked example at the most-pay figure: track and heads $175 + electrician labor $150 + dimmer $25 = $350. Against recessed lighting, track is the cheaper retrofit in Angi's comparison: recessed runs up to $400 per light where wiring or ductwork must be worked around, while track needs no drywall cuts. For the closest alternatives, see our recessed lighting installation guide, for single drops over an island, see our pendant light installation guide, and for task light under cabinets, see our under-cabinet lighting installation guide.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Costs in your city

Labor is the biggest variable in any remodel, and labor is local — the same bathroom can price very differently in Houston than in Boston. We are adding city editions metro by metro, each with its own labor index, permit notes and climate factors, written for that city rather than copied from this page. Wave 1: Houston, Dallas–Fort Worth, Phoenix, Atlanta, Miami–South Florida, Orlando, Tampa, Charlotte, Austin and San Antonio. Until your city's page is live, use the national range here and weight it the way contractors do: Sun Belt labor often prices near or below the national middle, while coastal California and the Northeast metros often price well above it.

How this estimate was built: the range on this page is a synthesis of at least three published industry sources (national cost guides and the Remodeling Magazine Cost vs. Value data among them), cross-checked in October 2026. We publish planning ranges, never a single pretend-precise price. Full method: How We Estimate Costs.
A short three-head kitchen track — the entry end of this page at $100–$300, where the box and wiring were already in place.
A short three-head kitchen track — the entry end of this page at $100–$300, where the box and wiring were already in place.

Frequently asked questions

How much does track lighting installation cost?

Typically $200–$500 for one track run with its heads at an existing junction box, with $350 the middle of that band — HomeAdvisor's $350 average per track fixture, inside Angi's and HomeGuide's $100–$300 per-system bands for the track itself.

How many heads can one track carry?

As many as the track length and circuit allow — the heads share a single feed from one junction box, so the practical limits are the track's length, the wattage and the coverage you want, not a per-head labor charge. Aimable heads are the point of track: point them at art, counters or seating, not at the ceiling.

Is track lighting cheaper than recessed lighting?

Usually, as a retrofit: Angi prices track installation at $100–$250 per fixture against recessed at up to $400 per light where wiring must be added or ductwork worked around, and track needs no drywall cutting or patching.

Do I need new wiring for track lighting?

Not if a junction box already sits where the track goes — the track mounts to it and the job stays in the $100–$300 band. A new location needs a new box and cable run, which Angi prices at $100–$200 on top.

Can a handyperson install track lighting?

A like-for-like swap at an existing box is within a handyperson's scope in Angi's guidance, but new wiring, a new junction box or a new location needs a licensed electrician — track work is mains-voltage work, not low-voltage.

Before you sign: get at least 3 written local quotes for the same written scope, confirm permits and who pulls them, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Track Lighting Installation cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides