Home › Cost Guides › Fence Repair
Cost Guide

How Much Does a Fence Repair Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$300 – $950
Most homeowners pay around $620 · The typical project is one damaged section made good — a post replaced or reset, a panel or a run of boards renewed, or a gate rehung — on a fence that is otherwise sound. A whole new fence is priced on the fence installation page.
typical
$300$950
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Backyard wooden fence with weathered and newer sections beside a shed

Fence Repair cost at a glance

  • Typical range: $300 – $950
  • Most homeowners pay: around $620
  • Prices vary most by: Repair labor (40–55% of the budget)

Cross-checked against three published sources for this project. Sources used for this page: the Angi fence repair cost guide, HomeGuide's fence repair cost data and Modernize's fencing cost guide. Sources last checked: October 2026 — HomeGuide, Modernize, Angi. How we calculate these costs

Cost by scope

Fence Repair cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Minor repair — boards, holes or hardware$100 – $300HomeGuide prices minor issues such as holes, cracks or missing boards at $100–$200; Angi prices holes or cracks at $125–$400, missing pickets or panels at $150–$300 and gate repair at $100–$400; Modernize prices replacing a broken panel at $100–$300.
Post or panel replacement — the typical job$300 – $950The typical project on this page. Angi averages $619 across 2,968 verified projects with most homeowners paying $304–$948; HomeGuide prices replacing posts or entire panels at $250–$750; Modernize prices a post repair or replacement at $150–$400 and gate work at $100–$500.
Long runs, leaning sections or storm damage$950 – $2,500+Angi prices fence repair by length at about $30 per foot — 30 feet at $540–$1,500 and 50 feet at $900–$2,500 — and a leaning fence at $200–$400 a section. Past roughly a fifth of the fence damaged, Angi's own repair-versus-replace guidance is to price a new fence instead.

Where the money goes

Part of the jobShareNote
Repair labor40–55%Angi prices fence repair labor at about $50 an hour, and digging out a post set in concrete and re-hanging a panel plumb is most of the visit — which is why a $20 board can honestly sit inside a $300 repair
Posts, panels & boards25–40%Angi prices a replacement post at about $270 on average and wood board replacement at $20–$60 per board in its wood-fence data; HomeGuide notes the material — wood, vinyl or metal — moves the total as much as the damage does
Concrete, fasteners & gate hardware8–15%The footing and the moving parts: Modernize prices gate repair or installation at $100–$500, and Angi prices hardware replacement at $30–$120 per set in its wood-fence repair data
Disposal & finish touch-up3–10%Old post concrete and broken panels have to leave, and repaired wood usually wants stain or paint to match its run — Angi prices fence staining at $3–$14 per linear foot when it is done as its own project
Repair labor · 40–55%Posts, panels & boards · 25–40%Concrete, fasteners & gate hardware · 8–15%Disposal & finish touch-up · 3–10%
Estimator’s note: on a fence repair, repair labor is usually where quotes swing most (40–55% of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
A double gate on its hinges and latch — gate repair runs $100–$400 in Angi, and Modernize prices gate work at $100–$500.
A double gate on its hinges and latch — gate repair runs $100–$400 in Angi, and Modernize prices gate work at $100–$500.

What moves the price most

The post is the fence. Boards and panels hang off posts, and a wood post set in concrete rots at ground level while the six feet above it still look sound — Angi prices resetting a leaning post at about $140 and replacing it at about $270 on average, which is why the same leaning section quotes two ways. Length is the unit: Angi prices repair at about $30 per linear foot all-in, so 10 damaged feet at $180–$500 and 50 feet at $900–$2,500 are the same job at different scales. Material reprices the foot — wood and chain-link average about $20 per foot in Angi, vinyl and wrought iron about $30, and glass about $100. Labor is local: about $50 an hour in Angi, and rocky soil, slopes and tight access are all bought by that hour. Finally, damage share decides repair versus replace — Angi flags a fence with more than about 20% of its posts, panels or pickets damaged as a replacement candidate, at $1,900–$4,750 for a whole fence in its data.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Worked example: how a typical fence repair budget breaks down

A typical one-section repair — the most common fence invoice there is — priced line by line from the bands on this page. The budget below totals $620 — the "most homeowners pay around" figure from the top of this page — split using this page's own cost breakdown. It shows how a real quote at that level is usually composed; every line is built from the ranges on this page, and it is an illustration, not a quote for your project.

Line itemExample budget
Replacement post, dug out & reset in concrete$270
Boards & panel section renewed$155
Gate hardware & rehang$120
Disposal & finish touch-up$75
Total$620

What most people get wrong

  • Straightening a fence on rotted posts. A reset costs about $140 in Angi and a replacement about $270 — the cheap fix on a dead post is the expensive one by next season.
  • Quoting by the section without a length. Angi prices repair at about $30 per linear foot all-in; a quote that never measures the run is a guess with a logo on it.
  • Skipping the neighbour conversation. Boundary-fence costs are usually shared — the argument is much cheaper before the work than after it.
  • Repairing a fence that is mostly gone. Past roughly 20% damage, Angi's own guidance flips to replacement; section repairs on a dying fence are instalments on a new one.

Costs in your city

Fence repair tracks two local things: the $50-an-hour labor band in Angi, which runs higher in the big metros, and what the ground does to posts. Freeze-thaw country heaves footings and leans fences; termite and wet-climate country rots posts at ground level; rocky soil turns a one-hour dig into a half-day one. Material stock matters too — vinyl and aluminum sections are matched by panel, not by the board, so a single damaged vinyl panel in a discontinued profile can price like several wood sections. The quote to trust anywhere names the post count and the footage, because $30 a foot is the yardstick every honest bid here is measured against.

How we got these numbers

Cross-checked against the Angi fence repair cost guide (average $619 across 2,968 verified projects; most homeowners paying $304–$948; about $30 per linear foot; labor about $50 an hour), HomeGuide's fence repair cost data (minor repairs $100–$200; post or panel replacement $250–$750) and Modernize's fencing cost guide (panel $100–$300; post $150–$400; gate $100–$500). The typical band published here is Angi's most-homeowners range rounded; the most-pay figure is Angi's verified average. Checked October 2026. Full method: How We Estimate Costs.

Pickets and rails up close — replacing a post runs about $270 on average in Angi, and individual boards $20–$60 each in its wood-fence data.
Pickets and rails up close — replacing a post runs about $270 on average in Angi, and individual boards $20–$60 each in its wood-fence data.

Frequently asked questions

How much does fence repair cost on average?

Angi averages $619 across 2,968 verified projects, with most homeowners paying $304–$948. HomeGuide prices the common jobs underneath that average — minor board and hole repairs at $100–$200 and post or panel replacement at $250–$750 — and Modernize prices a post at $150–$400. The average is a section-sized job, not a whole fence.

How much does it cost to replace a fence post?

Angi puts a replacement post at about $270 on average, against about $140 to dig out, reposition and reset a post that is still sound. HomeGuide's post-and-panel band is $250–$750 and Modernize prices post work at $150–$400 — the spread is the concrete footing: a post that comes out clean is a different job from one whose rotted stub has to be broken out of its footing by hand.

How much does it cost to fix a leaning fence?

Angi prices a leaning fence at $200–$400. The lean is a symptom: the honest quote names whether the post is being reset (about $140 in Angi) or replaced (about $270), because a straightened fence on a rotted post leans again within a season or two.

Who pays to repair a shared fence?

Usually both neighbours, in equal shares: HomeGuide's guidance is that responsibility for a boundary fence is typically split between the adjoining owners, unless one side caused the damage — a fallen tree or one neighbour's building work — in which case that side usually pays. Local rules vary, so the conversation comes before the contractor, not after the invoice.

Should I repair or replace my fence?

Repair while the damage is a minority of the fence. Angi's rule of thumb flags more than about 20% damage to posts, panels or pickets — or a fence past about 15 years with widespread rot or leaning — as replacement territory, with a whole new fence at $1,900–$4,750 in its data against typical repairs of $300–$950.

Before you sign: A fence fails one post at a time, and the repair bill is fair exactly when it says which post, how many feet, and what was under the ground. — The RemodelCostHub Editors

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Fence Repair cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides

Stucco house with tiled roofs at several heights and a brick driveway

Gutter Cleaning Cost

$100 – $250

The typical project is one full professional clean of a standard home — debris cleared from about 150–200 linear feet of gutter, downspouts flushed and flow checked. New gutters are priced on the gutter installation page and guards on the gutter guard installation page; neither is blended into this cleaning band.

Worker in a yellow raincoat pressure washing grey house siding from behind

Pressure Washing Cost

$200 – $400

The typical project is a professional wash of a standard home’s siding — soft-washed where the material needs it — on a one- or two-story house. A single driveway or patio, a roof soft wash and a whole-property bundle are tiered separately below; gutter cleaning by hand is priced on the gutter cleaning page.

Weathered wooden picket fences enclosing a suburban backyard on three sides

Fence Staining Cost

$750 – $2,100

The typical project is a professional stain of a standard 6-foot wood privacy fence, about 150 linear feet, washed and prepped first — about $0.50 – $2.50 per sq ft of fence surface in HomeGuide. A short picket run, painting instead of staining and both-sides shadow-box work are tiered separately below; a new fence is priced on the fence installation page.

Asphalt driveway leading to a detached garage under trees

Driveway Sealing Cost

$400 – $800

The typical project is professional sealcoating of a standard two-car asphalt driveway, about 400 sq ft — about $1 – $2 per sq ft installed in HomeGuide. Concrete sealing, two-coat work and crack-heavy driveways are tiered separately below; a new driveway is priced on the concrete driveway and driveway pages, not here.

Worker in helmet and visor cutting into a standing conifer trunk with a chainsaw

Tree Removal Cost

$385 – $1,070

The typical project is one mid-size yard tree — 30 to 60 ft — rigged down in sections by a two- or three-person crew and hauled away the same day, at about $10 – $14 per foot of height in LawnStarter. Small trees with a clear drop zone and oversize or crane-served trees are tiered separately below; stump grinding is priced as its own line, not folded into the takedown price.

A yellow bulldozer grading a dusty cleared lot with green trees behind it

Land Clearing Cost

$1,400 – $6,200

Land clearing typically costs $1,400 – $6,200 for a standard one-acre residential job, with about $3,800 the figure most jobs land near — Angi averages $3,778 across 2,416 verified projects with most homeowners paying $1,397–$6,173, HomeGuide prices clearing at $1,200–$8,000 per acre by vegetation density, and Fixr prices it at $500–$5,000 per acre. The $1,400–$6,200 typical band is Angi's most-pay band, and $3,800 is Angi's published average rounded — a lightly wooded acre costs far less, and a heavily wooded acre with full stump removal costs far more, while grading, soil testing and permits are priced separately and are not inside this band.