Home › Cost Guides › Tankless Water Heater Installation
Cost Guide

How Much Does a Tankless Water Heater Installation Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$1,400 – $3,900
Most homeowners pay around $2,650 · The typical project is a whole-house tankless unit replacing a storage tank in the same utility area — the unit, standard venting and connections, permits and the old tank removed. Gas-line extensions, panel upgrades and condensing models move real money on top of that and are priced separately below; for a like-for-like tank swap instead, see the water heater replacement guide.
typical
$1,400$3,900
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Technician in gloves servicing an open wall-mounted water heating unit beside a storage cylinder

Tankless Water Heater Installation cost at a glance

  • Typical range: $1,400 – $3,900
  • Most homeowners pay: around $2,650
  • Prices vary most by: The tankless unit (40–45% of the budget)

Cross-checked against three published sources for this project. Sources used for this page: Angi's tankless water heater cost guide, HomeGuide's tankless water heater cost guide and Forbes Home's tankless water heater cost data. Sources last checked: October 2026 — Forbes Home, HomeGuide, Angi. How we calculate these costs

Cost by scope

Tankless Water Heater Installation cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Standard whole-house tankless, standard install$1,400 – $3,900The typical project on this page. Angi's installed range is $1,404–$3,902 with an average of about $2,640, Forbes Home prices tankless installation at $1,000–$3,500 with units at $600–$1,500, and HomeGuide's total installed band starts at the same $1,400.
Electric whole-house tankless$1,400 – $3,000No venting and no gas work, but a serious electrical appetite. HomeGuide totals electric models at $1,400–$3,000 installed with units at $600–$1,000, and prices the dedicated circuit many of them need at $250–$900 on top where the panel has no room.
Gas condensing model or upgraded utilities$2,100 – $5,600Where the utility work joins the project. HomeGuide totals natural-gas models at $2,100–$5,600 installed with units at $1,500–$2,600, and its upgrade lines — a gas line at $350–$2,000, vent replacement at $100–$600, a panel replacement at $850–$1,700 — are what carry a quote to the top of the band.

Where the money goes

Part of the jobShareNote
The tankless unit40–45%HomeGuide prices the unit at 40–45% of the installed total — $600–$2,600 by fuel and capacity — and Forbes Home prices units at $600–$1,500; physical size is small, output in gallons per minute is what is being bought
Installation labor35–42%Mounting, water, gas or electrical connections, venting and commissioning. HomeGuide prices labor at $600–$2,500, and a tank-to-tankless conversion is slower than a tank swap because almost nothing lines up with the old pipework
Venting, gas line & electrical work8–18%The swing section: HomeGuide prices vent replacement at $100–$600, a gas line at $350–$2,000 and a dedicated circuit at $250–$900 — a same-spot swap with the right utilities barely touches this line, a relocation lives in it
Permits & old tank removal4–8%Angi budgets $200–$500 extra across permits, electrical upgrades and old heater removal, and HomeGuide prices permits at $50–$200 and removal of the old tank at $75–$500 — small lines that are never zero
The tankless unit · 40–45%Installation labor · 35–42%Venting, gas line & electrical work · 8–18%Permits & old tank removal · 4–8%
Estimator’s note: on a tankless water heater installation, the tankless unit is usually where quotes swing most (40–45% of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
The space argument in one closet: a wall-hung unit occupies a fraction of a tank footprint — HomeGuide totals electric whole-house models at $1,400–$3,000 installed, with the unit itself at $600–$1,000
The space argument in one closet: a wall-hung unit occupies a fraction of a tank footprint — HomeGuide totals electric whole-house models at $1,400–$3,000 installed, with the unit itself at $600–$1,000

What moves the price most

Fuel type sets the shape of the bill. HomeGuide totals electric models at $1,400–$3,000 and natural-gas models at $2,100–$5,600: gas units cost more and need venting and a gas supply sized for a much larger burner, while electric units are cheaper to buy and hangrier for amperage. Condensing versus non-condensing is a clean 25%: HomeGuide prices non-condensing models about 25% below condensing ones, which recover heat from the exhaust and vent in cheaper pipe. Flow rate is the sizing number — the unit is bought by gallons per minute at your groundwater temperature, and an undersized unit is a cold shower with a new price tag. The utilities decide the extras: a gas line at $350–$2,000, a panel replacement at $850–$1,700 and vent work at $100–$600 in HomeGuide are all 'if needed' lines, which is why two quotes for the same unit can differ by a thousand dollars honestly. And the payback frame is lifespan: HomeGuide rates tankless units at 15–20 years against 8–12 for a tank, so the premium is partly buying the replacement you will not make.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Worked example: how a typical tankless water heater installation budget breaks down

A typical job: a whole-house gas tankless unit mounted where the old tank stood — the tank drained and hauled away, venting run in new pipe, the gas line extended a short run, permits pulled and the unit commissioned with the temperature set. The budget below totals $2,650 — the "most homeowners pay around" figure from the top of this page — split using this page's own cost breakdown. It shows how a real quote at that level is usually composed; every line is built from the ranges on this page, and it is an illustration, not a quote for your project.

Line itemExample budget
The tankless unit (whole-house, gas)$1,140
Installation labor$1,060
Venting, gas line & connections$290
Permits & old tank removal$160
Total$2,650

What most people get wrong

  • Comparing unit prices instead of installed prices — HomeGuide puts the unit at 40–45% of the total, so the $600 difference between two units is not the $2,000 difference between two installed quotes.
  • Sizing by bathrooms instead of flow — the unit is bought by gallons per minute at your groundwater temperature, and an undersized tankless is a cold shower that a bigger tank would have handled.
  • Discovering the panel or gas line after signing — HomeGuide prices a panel replacement at $850–$1,700 and a gas line at $350–$2,000; both should be inspected and priced before the contract, not during the install.
  • Ignoring water hardness — scale is the tankless killer, and in hard-water areas the softener or descaling schedule is part of the installation decision, not an afterthought.

Costs in your city

Tankless pricing splits into a national unit price and very local utility conditions. The unit itself runs $600–$2,600 in HomeGuide wherever it is bought, but permits run $50–$200 in the same guide and are set by your jurisdiction, and labor follows your market's plumber rates. Climate enters through the groundwater: colder incoming water lowers a unit's effective gallons-per-minute, so northern homes honestly need the larger unit for the same showers — a sizing cost, not an upsell. Gas country installs cheaper than electric country at the top end, because HomeGuide's electric band of $1,400–$3,000 assumes the panel can feed the unit, and a panel replacement at $850–$1,700 erases the saving. Ask each bidder for the unit's flow rating at your winter groundwater temperature, and which utility upgrades are inside the number.

How this estimate was built: tankless figures were cross-checked across Angi's tankless water heater cost data (installed range $1,404–$3,902, average about $2,640, with $200–$500 extra budgeted for permits, electrical upgrades and old heater removal), HomeGuide's tankless water heater cost guide (total installed $1,400–$5,600, electric models $1,400–$3,000 and natural gas $2,100–$5,600, the unit at 40–45% of the total at $600–$2,600, labor $600–$2,500, gas lines $350–$2,000, panel replacement $850–$1,700, lifespan 15–20 years) and Forbes Home's published tankless cost data (units $600–$1,500, installation $1,000–$3,500) — so the typical band is the Angi installed range, which contains the Forbes band, and electric and upgrade-heavy gas jobs are tiered separately from HomeGuide. Checked October 2026. Full method: How We Estimate Costs.
The connections are the conversion: gas, water and venting are re-made at the new unit, and HomeGuide prices the add-ons honestly — a gas line at $350–$2,000 and vent replacement at $100–$600 where the existing runs cannot serve
The connections are the conversion: gas, water and venting are re-made at the new unit, and HomeGuide prices the add-ons honestly — a gas line at $350–$2,000 and vent replacement at $100–$600 where the existing runs cannot serve

Frequently asked questions

How much does it cost to install a tankless water heater?

Most homeowners pay $1,400–$3,900 for a whole-house tankless water heater installed, with $2,650 typical. Angi's range is $1,404–$3,902 with an average of about $2,640, HomeGuide totals installed jobs at $1,400–$5,600 across fuel types, and Forbes Home prices installation at $1,000–$3,500.

Is a tankless water heater more expensive than a tank?

To install, yes; over its life, it closes much of the gap. HomeGuide totals a tank water heater at $600–$3,100 installed against $1,400–$5,600 for tankless, but rates the tankless unit at 15–20 years of life against 8–12 for the tank — the tank is cheaper twice if it is replaced twice.

How much does a tankless unit cost by itself?

HomeGuide prices units at $600–$2,600 — electric models at $600–$1,000, propane at $1,000–$2,000 and natural gas at $1,500–$2,600 — and Forbes Home prices units at $600–$1,500. The unit is 40–45% of the installed total in HomeGuide, so a unit price is never the project price.

What extra work can a tankless installation need?

The utility upgrades: HomeGuide prices a gas line at $350–$2,000, vent replacement at $100–$600, a dedicated electrical circuit at $250–$900 and a panel replacement at $850–$1,700, and Angi budgets $200–$500 extra for permits, upgrades and old heater removal on a standard job. Ask which of these your house actually needs before comparing unit prices.

How long does a tankless water heater last?

HomeGuide rates tankless units at 15–20 years, against 8–12 years for a storage tank. Hard water shortens that: the heat exchanger scales, which is why installers in hard-water areas recommend a softener or scheduled descaling — the maintenance that protects the longest-lived part of the system.

Before you sign: confirm the unit is sized by flow at your winter groundwater temperature, get the gas line, venting, circuit and permit lines itemized in every quote, confirm old-tank removal is included, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

Tankless Water Heater Installation cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides

Finished basement bar and games room with a brick-look accent wall, wood ceiling and wood-look flooring

Basement Waterproofing Cost

$2,500 – $8,200

The typical project is a standard basement with seepage at the floor joint or through cracks, handled from inside with drainage, a sump and sealing — priced at $3–$10 per sq ft in Angi across methods. Full exterior excavation stops the water before the wall and is tiered separately; finishing a basement is priced on the basement finishing page.

Two workers coating and painting a wall in an unfinished room, one on a ladder at the ceiling line

Drywall Repair Cost

$300 – $900

The typical project is one professional visit covering a hole, a crack run or a small water-stained section — cut out, patched, taped, mudded, sanded and left paint-ready, priced at $50–$75 per sq ft of repaired area in Angi where pros price by the foot. Hanging new drywall across whole rooms is priced on the drywall installation page.

Man applying plaster to a block wall with a trowel and hawk

Plaster Repair Cost

$500 – $1,500

Repairing damaged plaster walls in an older home — cracks, holes and crumbling sections cut out, patched and finished; a full-room replaster, a ceiling rebuild or water-damage restoration priced separately

Empty room with wall-to-wall light grey carpet and large windows

Carpet Cleaning Cost

$125 – $250

The typical project is a professional hot-water extraction clean of one to three carpeted rooms, priced per room with a minimum visit fee. Whole-house packages and stain, odor and furniture add-ons are tiered separately below; brand-new carpet is priced on the carpet installation page.

Technician servicing an open rooftop HVAC unit with a cordless drill

Air Duct Cleaning Cost

$300 – $550

The typical project is a whole-system clean of an average home — every supply and return vent, the trunk lines and the air handler — at about $0.15 – $0.30 per sq ft of living space in Angi. A partial clean, dryer-vent add-ons and mold or post-renovation work are tiered separately below; new ductwork belongs to an HVAC replacement, not this page.

Gloved hand pulling a brass squeegee across a soapy window pane

Window Cleaning Cost

$150 – $300

The typical project is a professional inside-and-out clean of a standard one- or two-story home — about $8 – $16 per window inside and out in HomeGuide. Exterior-only work, screen and track add-ons and high or post-construction cleaning are tiered separately below; new windows are priced on the window replacement page.