Home › Cost Guides › French Drain Installation
Cost Guide

How Much Does a French Drain Installation Cost? (2026)

By Ahsan ul Haq · Last updated: 11 November 2026 · Planning estimate — not a quote · How we estimate

Typical range
$2,000 – $8,000
Most homeowners pay around $5,000 · Exterior yard or perimeter French drain — LawnStarter's 2026 national average is $5,000 installed
typical
$2,000$8,000
Low end = minor scope  ·  marker = typical middle  ·  high end = major scope. Add 10–20% contingency to any budget.
Construction trench with gravel bed and drainage pipes on a suburban site

French Drain Installation cost at a glance

  • Typical range: $2,000 – $8,000
  • Most homeowners pay: around $5,000
  • Prices vary most by: Labor (trenching, laying, backfill) (≈ 60–70% of the budget)

Cross-checked against four published sources for this project. Sources used for this page: the Angi French drain cost guide (May 2026), LawnStarter's 2026 French drain cost guide, Fixr's landscaping and yard-reslope cost data and HomeGuide's French drain cost guide (Angi family — component detail only). Sources last checked: October 2026 — HomeGuide, Fixr, Angi, LawnStarter. How we calculate these costs

Cost by scope

French Drain Installation cost ranges by scope — chart of the table below
ScopeTypical costWhat it includes
Shallow yard / curtain drain$10 – $35 per linear footA shallow gravel-and-pipe trench intercepting surface water — the budget route when the water is on the surface
Exterior perimeter at footing depth$30 – $90 per linear footDeep trench with weeping tile around the foundation — the trench depth and foundation exposure are the cost
Interior basement perimeter$40 – $100 per linear footPerimeter channel inside the basement slab, usually with a sump pump — the dearest common type
Behind a retaining wall$25 – $50 per linear footDrainage relieving hydrostatic pressure behind the wall — priced by the wall's length and height

Where the money goes

Part of the jobShareNote
Labor (trenching, laying, backfill)≈ 60–70% of totalThe single biggest share in Angi — trenching by machine or by hand, pipe laying, gravel and backfill
Pipe, gravel & fabric$250 – $1,500 on a 100-ft jobHomeGuide's factor table: pipe $100–$1,000+, drainage gravel $100–$600, permeable fabric $40–$360
Sump pump (where needed)$500 – $2,000 installedAngi's installed band; HomeGuide prices adding a pump to an existing drain at $600–$2,500
Permits, inspection & yard restoration$150 – $600Permits $50–$375 across the three sources; sod restoration $0.87–$1.76 a square foot in LawnStarter
Estimator’s note: on a french drain installation, labor (trenching, laying, backfill) is usually where quotes swing most (≈ 60–70% of total of a typical budget). Ask every contractor to itemize that line in writing — totals are only comparable when that part is.
Pipe on gravel, the anatomy of the drain — HomeGuide specs 2–3 inches of gravel under the pipe and 3–4 over it, and the pipe, gravel and fabric together run $250–$1,500 on a 100-foot job.
Pipe on gravel, the anatomy of the drain — HomeGuide specs 2–3 inches of gravel under the pipe and 3–4 over it, and the pipe, gravel and fabric together run $250–$1,500 on a 100-foot job.

What moves the price most

Drain type and depth are the budget. A shallow yard drain ($10–$35 a linear foot), an exterior perimeter at footing depth ($30–$90), an interior basement perimeter ($40–$100) and a retaining-wall drain ($25–$50) are different trenches at different prices — a per-foot quote without the depth is not a quote. Length scales everything: HomeGuide's tables run 25 to 250 feet, and a 200-foot interior perimeter ($8,000–$17,000) is a different project from a 50-foot yard drain ($500–$3,250 in LawnStarter). The discharge plan is the hidden line — a drain with nowhere to go needs a dry well ($500–$3,000 in LawnStarter) or a storm-drain tie-in ($500–$3,500), and the sump pump ($500–$2,000) belongs in the interior number from the start. Soil and access move the labor share: clay and rock dig slower, and Angi puts labor at 60–70% of the project.

Work out your quantities: before you compare quotes, run your measurements through our free remodeling calculators (paint, tile, concrete and flooring) — each one shows its formula and runs entirely in your browser.

Worked example: how a typical french drain installation budget breaks down

Take the typical job — a 100-foot exterior yard drain: trench 12–24 inches deep, perforated pipe on a gravel bed wrapped in permeable fabric, backfilled and graded, discharging to daylight. Here is a realistic $5,000 version of that invoice, at LawnStarter's 2026 national average: The budget below totals $5,000 — the "most homeowners pay around" figure from the top of this page — split using this page's own cost breakdown. It shows how a real quote at that level is usually composed; every line is built from the ranges on this page, and it is an illustration, not a quote for your project.

Line itemExample budget
Labor & trenching (machine + hand work)$3,100
Pipe, gravel & landscape fabric$900
Sump pump + discharge line$700
Permits, inspection & sod restoration$300
Total$5,000

What most people get wrong

  • Sizing the drain by the wet spot instead of the water source. A curtain drain where a footing-depth perimeter is needed (or the reverse) is the wrong trench at the wrong depth — HomeGuide prices shallow yard work at $10–$35 a foot against $30–$90 at footing depth, and the type decision comes before the per-foot math.
  • Signing a quote with no discharge plan. A drain with nowhere to go is a very expensive hole: LawnStarter prices a dry well at $500–$3,000 and a storm-drain tie-in at $500–$3,500 — confirm the outlet is inside the number before the trench is dug.
  • Accepting an interior quote with no pump line. Angi prices sump pump installation at $500–$2,000, and interior systems typically include one — a basement perimeter quote without it is either incomplete or quietly assuming gravity will do a pump's job.
  • Comparing per-foot quotes without the depth. $10 a foot shallow and $90 a foot deep are different trenches, different equipment and different days — Angi's own location table runs $20–$30 a foot for a yard against $60–$70 for a basement, so make every bidder state the depth.

Costs in your city

Drain pricing is trenching-labor pricing around commodity pipe and gravel: Angi puts labor at 60–70% of the project, so the same 100-foot drain quotes near the bottom of the band where crew rates are low and toward the top in a high-cost metro, while the pipe itself costs the same everywhere. Soil is the local multiplier — clay and rock dig slower than loam, and rocky ground can force equipment upgrades mid-job. Basement prevalence matters too: markets where basements are standard price far more interior perimeter work ($40–$100 a foot) than slab-on-grade markets. Permits run $50–$375 across the sources, and some municipalities require inspector sign-off before the drain is covered. Call 811 before any digging, and ask each bidder for the depth, the discharge point and the pump as separate lines.

How we got these numbers

Cross-checked against the Angi French drain cost guide — read in full this run, May 2026 (national average $9,250; range $500–$18,000; $10–$100 a linear foot; interior $40–$100; exterior $10–$50; labor 60–70% of the project; permits $50–$200; 30–40 year lifespan), LawnStarter's 2026 French drain cost guide — read in full this run (national average $5,000; typical $1,650–$12,250; exterior $10–$65 a foot; interior $40–$100; 100-foot exterior $1,000–$6,500; DIY about $700 against roughly $3,000 pro; dry well $500–$3,000; storm-drain tie-in $500–$3,500) and Fixr's landscaping and yard-reslope cost data — read in full this run (about $4,500; $2,800–$6,500 — Fixr publishes no dedicated French drain guide, so its figures are thin and are flagged as such, never used alone). HomeGuide's French drain cost guide (Angi Inc family — not counted as an independent source) supplied the component tables: pipe $100–$1,000+, gravel $100–$600, fabric $40–$360, sump pump $500–$1,800 installed, permits $100–$375. Angi's $9,250 average is published as a genuine disagreement — roughly double the other two averages, consistent with a data mix carrying far more interior basement work. Breakdown shares are derived from the guides' dollar figures where marked. Checked October 2026. Full method: How We Estimate Costs.

The discharge end — every drain needs somewhere for the water to go: daylight, a dry well ($500–$3,000 in LawnStarter) or a storm-drain tie-in ($500–$3,500). A drain with no outlet is a very expensive hole.
The discharge end — every drain needs somewhere for the water to go: daylight, a dry well ($500–$3,000 in LawnStarter) or a storm-drain tie-in ($500–$3,500). A drain with no outlet is a very expensive hole.

Frequently asked questions

How much does a French drain cost?

$2,000–$8,000 is the typical installed band for an exterior yard or perimeter drain, and LawnStarter's 2026 national average is $5,000. Angi's published average is much higher at $9,250 — its data mixes in far more interior basement work, and the page names that disagreement honestly.

What does a French drain cost per linear foot?

$10–$65 a linear foot for exterior drains and $40–$100 for interior basement perimeters in LawnStarter; Angi publishes $10–$100 overall. HomeGuide splits it finer: $10–$35 for shallow yard work, $30–$90 at footing depth, $40–$85 for interior basement.

Do I need an interior or exterior French drain?

Exterior drains intercept water before it reaches the house — yard drains and footing-depth perimeter tile. Interior perimeter drains manage water that gets under the slab, and they almost always include a sump pump. A wet basement usually means interior; a soggy yard usually means exterior.

Does a French drain need a sump pump?

Interior basement systems typically include one — gravity alone will not move water from under a slab. Angi prices sump pump installation at $500–$2,000, and HomeGuide prices adding a pump to an existing drain at $600–$2,500.

How long do French drains last?

30–40 years with regular maintenance across Angi, HomeGuide and LawnStarter. HomeGuide recommends cleaning at least once a year ($80–$500+ by a contractor), and notes sump-pump systems typically need service within 10 years.

Can I install a French drain myself?

A shallow yard drain is the realistic DIY case: LawnStarter prices DIY at about $700 against roughly $3,000 professionally, with a trencher renting at $85–$200 a day. Foundation-depth trenches over 4 feet, interior work and anything near utilities belong to a pro — and call 811 before any digging.

Before you sign: confirm the drain type, depth and discharge point in writing before comparing quotes, keep the sump pump as its own line on interior work, call 811 before any trench is opened, and keep a 10–20% contingency separate from the contract price.

Ahsan ul Haq — Editor, Remodel Cost Hub

Ahsan compiles and edits the cost guides on Remodel Cost Hub, cross-checking every range against at least three published sources before it is published — the full method is on our Methodology page. Spot an error on this page? Send a correction.

French Drain Installation cost range graphic
Save this range for later: Pin it on Pinterest

Related cost guides