Dryer Repair cost at a glance
- Typical range: $100 – $430
- Most homeowners pay: around $180
Cross-checked against three published sources for this project. Sources used for this page: Angi's dryer repair cost guide (updated September 2026, average $180, most paying $100–$430), Thumbtack's 2026 dryer repair cost guide (most paying around $203 inside $127–$324) and HomeGuide's appliance repair cost guide (dryer repair $100–$300 on average). Sources last checked: October 2026 — HomeGuide, Angi, Thumbtack. How we calculate these costs
Cost by scope

| Scope | Typical cost | What it includes |
|---|---|---|
| Minor fix — switch, fuse, belt | $15 – $250 | The small jobs: won't turn on at $15–$300 and not spinning at $30–$250 (Angi problem table), with parts-only prices of $5–$18 for a thermal fuse and $14–$32 for a drive belt (Angi) |
| Standard repair — the typical band | $100 – $430 | The shared band itself: not heating at $80–$420 and overheating at $90–$320 (Angi), inside Thumbtack's $127–$324 range and HomeGuide's $100–$300 band |
| Major repair — motor, control board, electrics | $250 – $600 | The expensive end: loud noises to $450 and sparks or smells at $400–$600 (Angi), with parts-only prices of $90–$280 for a control board and $60–$150 for a motor (Angi) — labour sits on top of those part prices |
Where the money goes
| Part of the job | Share | Note |
|---|---|---|
| Labour | $50 – $100 per hour | Angi's hourly band; Angi notes labour can be 90% or more of a dryer repair bill |
| Service call fee | $50 – $80 | Angi's service-call band, on top of hourly labour; Thumbtack's service-fee band is $30–$100 |
| Not heating | $80 – $420 | Angi's problem-table band: bad heating element, thermostat or blown thermal fuse |
| Not spinning | $30 – $250 | Angi's problem-table band: broken drive belt, motor fault or worn drum rollers |
| Won't turn on | $15 – $300 | Angi's problem-table band: bad door switch, start switch or control board |
| Shuts off quickly | $25 – $300 | Angi's problem-table band: overheating from a clogged vent or a bad thermostat |
| Overheating | $90 – $320 | Angi's problem-table band: clogged vent or malfunctioning thermostat |
| Loud noises | $10 – $450 | Angi's problem-table band: faulty drum bearing, loose belt, broken motor or loose screws |
| Sparks or smells | $400 – $600 | Angi's problem-table band: malfunctioning electrics, which usually means replacing the unit |
| Control board (part only) | $90 – $280 | Angi's part-table price, labour extra; Angi calls the control board the most expensive dryer part |
| Motor (part only) | $60 – $150 | Angi's part-table price, labour extra |
| Drive belt (part only) | $14 – $32 | Angi's part-table price, labour extra |
| Drum rollers (part only) | $20 – $55 | Angi's part-table price, labour extra |
| Thermostat (part only) | $15 – $60 | Angi's part-table price, labour extra |
| Thermal fuse (part only) | $5 – $18 | Angi's part-table price, labour extra |
| Vent repair | $75 – $150 | Angi's vent-repair band when the existing vent can be salvaged |
| Vent replacement | $100 – $300 | Angi's vent-replacement band when the vent cannot be repaired |

What moves the price most
Repair type is the biggest driver, followed by dryer type: gas dryers cost $50–$100 more to repair than electric models (HomeAdvisor), because gas parts are harder to find. Vent condition matters as much as any part: a clogged vent causes overheating and shut-offs (Angi), and vent repair runs $75–$150 against $100–$300 for replacement (Angi). Age is where the sources disagree: Angi puts dryer lifespan at 10–13 years while HomeGuide's appliance guide puts it at 6–10 years, so the repair-or-replace line moves with the source. New dryers run $400–$2,000 from entry-level to top of the line (Thumbtack) against $800–$1,200 for the unit alone (HomeGuide), and labour dominates: Angi notes it can be 90% or more of the bill, which is why a $14 belt can still be a $100-plus job.
Costs in your city
Labor is the biggest variable in any remodel, and labor is local — the same bathroom can price very differently in Houston than in Boston. We are adding city editions metro by metro, each with its own labor index, permit notes and climate factors, written for that city rather than copied from this page. Wave 1: Houston, Dallas–Fort Worth, Phoenix, Atlanta, Miami–South Florida, Orlando, Tampa, Charlotte, Austin and San Antonio. Until your city's page is live, use the national range here and weight it the way contractors do: Sun Belt labor often prices near or below the national middle, while coastal California and the Northeast metros often price well above it.

Frequently asked questions
How much does dryer repair cost?
Typically $100–$430, with about $180 the most-pay figure. Angi's 2026 average is $180 inside $100–$430, Thumbtack puts most people around $203 inside $127–$324, and HomeGuide's appliance guide puts dryer repair at $100–$300 on average — the three sources agree on this page's band.
Why do Angi and HomeGuide disagree on dryer lifespan?
Angi puts dryer lifespan at 10–13 years while HomeGuide's appliance guide puts it at 6–10 years. This page publishes both figures rather than picking one, so a 9-year-old dryer sits inside Angi's mid-life but at the end of HomeGuide's range.
How much does a dryer heating element replacement cost?
Angi does not price the element part on its own: it prices the not-heating job at $80–$420 in total, which covers a bad heating element, thermostat or blown thermal fuse. The element part itself is inside that job total, not a separate published figure on Angi's page.
Should I repair or replace my dryer?
Repair if the job costs under half a new dryer and the unit is well inside its lifespan; replace if sparks or smells appear ($400–$600 on Angi's table, usually a replacement case) or the repair passes half the replacement price. A new dryer runs $400–$2,000 (Thumbtack) or $800–$1,200 for the unit alone (HomeGuide).
Why is my dryer not heating?
The usual suspects are a blown thermal fuse ($5–$18 part only), a bad thermostat ($15–$60 part only) or a failed heating element (Angi) — but check the vent first, since a clogged vent causes overheating and shut-offs, and vent repair runs $75–$150 against $100–$300 for replacement (Angi).






